ON-VEHICLE INSPECTION
Inspection · Vehicles built from Oct 2006
| INSPECT LICENSE PLATE LIGHT ASSEMBLY |
Disconnect the connector from the license plate light assembly.

Measure the voltage according to the value(s) in the table below.
- Standard voltage:
- LH Side:
Tester Connection
Condition
Specified Condition
S4-1 - S4-2
Light control switch OFF → TAIL
Below 1 V → 10 to 14 V
- RH Side:
Tester Connection
Condition
Specified Condition
S1-1 - S1-2
Light control switch OFF → TAIL
Below 1 V → 10 to 14 V
