2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Jun 2006


INSPECT NO. 1 ROOM LIGHT ASSEMBLY (w/o Sliding Roof)

  1. E116068
    Apply battery voltage to the No. 1 room light assembly connector.

  1. Check that the interior light comes on.

    OK:
    Measurement Condition
    Switch Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    DOOR
    Interior light comes on
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 3
    ON
    Interior light comes on

    If the result is not as specified, replace the bulb or room light assembly.


INSPECT SPOT LIGHT ASSEMBLY (w/ Sliding Roof)

  1. E121513E01
    Apply battery voltage to the spot light assembly connector.

  1. Check that the rear personal light comes on.

    OK:
    Measurement Condition
    Switch Condition
    Specified Condition
    Battery positive (+) → Terminal Q10-2
    Battery negative (-) → Terminal Q10-4
    Pushed (ON)
    Rear RH personal light comes on
    Battery positive (+) → Terminal Q10-2
    Battery negative (-) → Terminal Q10-3
    Always
    Rear RH personal light comes on
    Battery positive (+) → Terminal Q11-2
    Battery negative (-) → Terminal Q11-4
    Pushed (ON)
    Rear LH personal light comes on
    Battery positive (+) → Terminal Q11-2
    Battery negative (-) → Terminal Q11-5
    Always
    Rear LH personal light comes on

    If the result is not as specified, replace the bulb or spot light assembly.

← REMOVAL (from Jun 2009)INSTALLATION (Jun 2006 – Sep 2006) →