2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

B15E1 Media Malfunction

Diagnostic trouble codes · Vehicles built from Jun 2009

DESCRIPTION

This DTC is stored when signals from a disc in the navigation receiver assembly cannot be read.
DTC No.
DTC Detection Condition
Trouble Area
B15E1
When one of the conditions below is met:
  1. An unsuitable disc is inserted.
  2. The disc cannot be read.
  3. The disc cannot be read because of dirt or scratches.
  4. The disc cannot be read because it is inserted upside down.
  1. Disc
  2. Navigation receiver assembly

INSPECTION PROCEDURE


1. CHECK DISC

  1. I100152
    Check that the disc is not deformed or cracked.

    OK:
    No deformation or cracks on the disc



NG
CHANGE DISC
OK


2. DISC CLEANING

  1. I100151
    Disc cleaning
    1. If dirt is on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.

      NOTICE:
      Do not use a conventional record cleaner or anti-static preservative.


NEXT


3. REPLACE DISC WITH ANOTHER AND RECHECK
  1. Replace the disc with another and recheck.

  1. Clear the DTC (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.

    Result:
    Result
    Proceed to
    OK
    A
    NG
    (for 2GR-FE RHD)
    B
    NG
    (except 2GR-FE RHD)
    C



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (for 2GR-FE RHD) (Click here)

C
REPLACE NAVIGATION RECEIVER ASSEMBLY (except 2GR-FE RHD) (Click here)
A

END


← B15C2 Speed Signal Malfunction (from Jun 2009)U0073 Control Module Communication Bus Off (from Jun 2009) →