2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009


INSPECT STEERING PAD SWITCH

  1. Disconnect the steering pad switch assembly connector.

    E129804E05

  1. Measure the resistance according to the values in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    AU1 - EAU
    No switch is pushed
    95 to 105 kΩ
    AU1 - EAU
    Seek+ switch: push
    Below 2.5 Ω
    AU1 - EAU
    Seek- switch: push
    313.5 to 346.5 Ω
    AU1 - EAU
    Volume+ switch: push
    959.5 to 1060.5 Ω
    AU1 - EAU
    Volume- switch: push
    3049.5 to 3370.5 Ω
    AU2 - EAU
    No switch is pushed
    959.5 to 1060.5 Ω
    AU2 - EAU
    MODE switch: push
    Below 2.5 Ω
    AU2 - EAU
    Voice switch: push (*11)
    3049.5 to 3370.5 Ω
    AU2 - EAU
    On Hook switch: push (*11)
    313.5 to 346.5 Ω
    AU2 - EAU
    Off Hook switch: push (*11)
    959.5 to 1060.5 Ω

    Text in Illustration 
    *1
    Component without harness connected
    (Steering Pad Switch for 3 Spoke Type)
    *2
    Component without harness connected
    (Steering Pad Switch for 4 Spoke Type)
    *3
    Volume-
    *4
    Volume+
    *5
    Seek-
    *6
    Seek+
    *7
    MODE
    *8
    Off Hook*11
    *9
    On Hook*11
    *10
    Voice*11
    1. *11: w/ Microphone
    If the result is not as specified, replace the steering pad switch.

← INSPECTION (Jun 2006 – May 2009)INSTALLATION (Jun 2006 – Sep 2006) →