2006-2011 Camry Aurion · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Oct 2006


CHECK MASS AIR FLOW METER

NOTICE:
  1. Perform the MAF meter inspection by following the procedures below.
  2. Only replace the MAF meter when both the LONG FT#1 value and MAF value in the DATA LIST (with the engine stopped) are not within the normal operating range.

  1. Read values using the intelligent tester (Long FT#1).

    1. Select the following menu items: Powertrain / Engine / Data List / Long FT#1.

    2. Read the values displayed on the tester.

      Standard value:
      Within -15 to +15 %

      If the result is not within the specified range, perform the inspection below.

  1. Read values using the intelligent tester (MAF).

    NOTICE:
    1. Turn off the engine.
    2. Perform the inspection with the vehicle indoors and on a level surface.
    3. Perform the inspection of the MAF meter while it is installed to the air cleaner case (installed to the vehicle).
    4. During the test, do not use the exhaust air duct to perform suction on the exhaust pipe.


    1. Turn off the engine.

    2. Turn the engine switch on (IG).

    3. Turn the tester on.

    4. Select the following menu items: Powertrain / Engine / Data List / MAF.

    5. Wait 30 seconds, and read the values on the intelligent tester.

      Standard condition:
      Less than 0.56 g/s

      1. If the result is not as specified, replace the MAF meter.
      2. If the result is within the specified range, inspect the cause of the extremely rich or lean air fuel ratio.

← COMPONENTS (from Oct 2006)REMOVAL (from Oct 2006) →