REMOVAL
Removal / installation · Vehicles built Oct 2006 – May 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
| 1.
REMOVE FRONT DOOR SCUFF PLATE LH
|
 |
- Disengage the 7 claws and 3 clips, and remove the front door scuff plate LH.
| 2.
REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
|
 |
- Remove the cowl side trim clip.
Disengage the 2 clips and remove the cowl side trim sub-assembly LH.
| 3.
REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL LH
|
 |
- Remove the bolt <A> and the screw <B>.
Disengage the 2 claws and the DLC3.
Disconnect the hood lock control cable assembly.
Disengage the claw and the 4 clips.
Remove the air hose, disconnect the connector, and then remove the lower No. 1 instrument panel finish panel.
| 4.
REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY (for LHD)
|
 |
- Disengage the 3 claws and the 2 clips.
Disconnect each connector and remove the No. 1 instrument panel sub-assembly.
| 5.
REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY (for RHD)
|
 |
- Disengage the 3 claws and the 2 clips.
Disconnect the connector and remove the No. 1 instrument panel sub-assembly.
| 6.
REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Smart Entry and Start System)
|
 |
- Disengage the 2 claws and 2 clips, and then remove the lower instrument panel finish panel.
| 7.
REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/ Smart Entry and Start System)
|
 |
- Disengage the 2 claws and 2 clips, and then remove the lower instrument panel finish panel.
Disconnect the connector.
| 8.
REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
|
 |
- Remove the 2 clips.
Disengage the guide and 4 claws, and then remove the instrument cluster finish panel sub-assembly.
| 9.
REMOVE COMBINATION METER
|
 |
- Remove the 4 screws <E>.
Disconnect each connector and remove the combination meter assembly.
| 10.
REMOVE STOP LIGHT SWITCH |
 |
- Disconnect the stop light switch connector.
- Turn the stop light switch counterclockwise and remove the stop light switch.