Luggage Compartment Door Courtesy Switch Circuit
Circuit diagnosis · Vehicles built from Jun 2006
DESCRIPTION
The door courtesy switch turns on when the door is open and turns off when the door is closed.The main body ECU detects the condition of the door courtesy switch.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING DATA LIST (DOOR COURTESY SWITCH) |
Check the DATA LIST for proper functioning of the door courtesy switch.
Main Body Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Luggage Courtesy SW
Luggage compartment door courtesy light switch signal/ON or OFF
ON: Luggage compartment door is OPEN
OFF: Luggage compartment door is CLOSED
-
- OK:
- "ON" (door is open) and "OFF" (door is closed) appear on the screen.
|
|
||||
| OK | ||
| ||
| 2. INSPECT LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY (DOOR COURTESY SWITCH) |
Remove the luggage compartment door lock.

Measure the resistance between the specified terminals of the switch.
- Standard resistance:
Tester Connection
Condition
Specified Condition
2 - 3
UNLOCK
Below 1 Ω
2 - 3
LOCK
10 kΩ or higher
|
|
||||
| OK | |
| 3. CHECK WIRE HARNESS (LUGGAGE COMPARTMENT DOOR LOCK - MAIN BODY ECU) |
Disconnect the ECU connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection (Symbols)
Condition
Specified Condition
S5-3 - E6-25 (LGCY)
Always
Below 1 Ω
S5-3 - Body ground
Always
10 kΩ or higher
S5-2 - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
