Luggage Compartment Door Courtesy Switch Circuit
Circuit diagnosis · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
The luggage compartment door courtesy switch turns on when the door is open and turns off when the door is closed.The main body ECU (instrument panel J/B) detects the condition of the door courtesy switch.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE ON INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.


Turn the ignition switch on (IG) and turn the intelligent tester main switch on.
Select Luggage Courtesy SW in the DATA LIST and read the tester display.
Body: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Luggage Courtesy SW
Luggage compartment door courtesy light switch signal / ON or OFF
ON: Luggage compartment door is OPEN
OFF: Luggage compartment door is CLOSED
-
- OK:
- The display is as specified in the "Normal Condition" column.
|
|
||||
| OK | ||
| ||
| 2. INSPECT LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY (DOOR COURTESY SWITCH) |
Remove the luggage compartment door lock assembly (Click here).

Measure the resistance between the specified terminals of the switch.
- Standard resistance:
Tester Connection
Condition
Specified Condition
2 - 3
UNLOCK
Below 1 Ω
2 - 3
LOCK
10 kΩ or higher
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (LUGGAGE COMPARTMENT DOOR LOCK - MAIN BODY ECU) |
Disconnect the main body ECU (instrument panel J/B) connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection (Symbols)
Condition
Specified Condition
S5-3 - E6-25 (LGCY)
Always
Below 1 Ω
S5-3 - Body ground
Always
10 kΩ or higher
S5-2 - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
