2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. REMOVE FRONT BUMPER ASSEMBLY

  1. B220943E01
    Put protective tape around the front bumper assembly.

  1. B138884E01
    Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B220944
    Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.

  1. B220945
    Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. w/o Fog Light:

    1. Remove the front bumper assembly.

  1. w/ Fog Light:

    1. Disconnect each connector, and then remove the front bumper assembly.


2. REMOVE HIGH PITCHED HORN ASSEMBLY

  1. E127996
    Disconnect the connector.

  1. Remove the bolt and the high pitched horn assembly.

← REMOVAL (Oct 2006 – May 2009)INSPECTION (from Oct 2006) →