2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY

HINT:
Refer to the procedure up to Remove Instrument Panel Safety Pad Assembly (Click here).


2. REMOVE SIDE NO. 1 DEFROSTER NOZZLE DUCT

  1. B134016E02
    Remove the screw <F> and the side No. 1 defroster nozzle duct.


3. REMOVE SIDE NO. 2 DEFROSTER NOZZLE DUCT

  1. B134017E02
    Remove the screw <F> and the side No. 2 defroster nozzle duct.


4. REMOVE DEFROSTER NOZZLE ASSEMBLY

  1. B134018E02
    Remove the 3 screws <F> and the defroster nozzle assembly.


5. REMOVE NO. 1 HEATER TO REGISTER DUCT

  1. B134019E02
    Remove the 3 screws <F> and the No. 1 heater to register duct.


6. REMOVE NO. 3 HEATER TO REGISTER DUCT

  1. B134020E02
    Remove the 3 screws <F> and the No. 3 heater to register duct.


7. REMOVE NO. 2 HEATER TO REGISTER DUCT

  1. B134021E02
    Remove the 2 screws <F> and the No. 2 heater to register duct.


8. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (for LHD)

  1. Disengage the 6 clamps and clip and remove the No. 2 antenna cord sub-assembly.

    E194909


9. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (for RHD)

  1. Disengage the 6 clamps and clip and remove the No. 2 antenna cord sub-assembly.

    E194910


10. REMOVE ROOF HEADLINING ASSEMBLY

HINT:
Refer to the procedure up to Remove Roof Headlining Assembly (Click here).


11. REMOVE ANTENNA CORD SUB-ASSEMBLY
  1. Peel the strips of the tape used to secure the antenna cord only to the extent that allows removal of the antenna cord.

    HINT:
    Tape is not available as a supply part. Try to leave as much tape as possible on the roof headlining so that the tape can be reused.

  1. Remove the antenna cord from the roof headlining.

    E194900E01

← REMOVAL (Oct 2006 – May 2009)INSTALLATION (Oct 2006 – May 2009) →