INSPECTION
Inspection · Vehicles built Oct 2006 – May 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009
| INSPECT BRAKE CYLINDER AND PISTON |
Inspect the cylinder bore and the piston for rust or scoring. If necessary, replace the rear disc brake cylinder assembly and piston.
| INSPECT PAD LINING THICKNESS |
Using a ruler, measure the pad lining thickness.

- Standard thickness:
- 10.3 mm (0.406 in.)
- Minimum thickness:
- 2.0 mm (0.0787 in.)
- HINT:
- Be sure to check wear of the rear disc after replacing the brake pad with a new one.
| INSPECT DISC THICKNESS |
Using a micrometer, measure the disc thickness.

- Standard thickness:
- 10.0 mm (0.390 in.)
- Minimum thickness:
- 8.5 mm (0.334 in.)
| INSPECT DISC RUNOUT |
Install the rear disc.
Temporarily fasten the rear disc with the 3 hub nuts.
- Torque:
- 103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }
Using a dial indicator, measure the disc runout 10 mm (0.39 in.) away from the outer edge of the rear disc.

- Maximum disc runout:
- 0.15 mm (0.0059 in.)
- NOTICE:
- Keep the magnet of the dial indicator away from the axle hub and speed sensor.
- Install the dial indicator to the shock absorber.
- Keep the magnet of the dial indicator away from the axle hub and speed sensor.
If the runout exceeds the maximum value, change the installation positions of the disc and axle so that the runout will become minimal. If the runout exceeds the maximum even after the installation positions are changed, check the bearing play in the axial direction and the axle hub runout (Click here). If the bearing play and the axle hub runout are normal and if the disc thickness is not within the specified range, grind the disc. If the disc thickness is less than the minimum, replace the disc.
Remove the 3 hub nuts.
Remove the rear disc.
