2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Display Signal Circuit between Navigation Receiver Assembly and Television Camera Assembly

Circuit diagnosis · Vehicles built Oct 2006 – May 2009

DESCRIPTION

This is the display signal circuit of the television camera assembly.

WIRING DIAGRAM

E131098E12

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - TELEVISION CAMERA ASSEMBLY)
  1. Disconnect the F12 connector from the navigation receiver assembly.

  1. Disconnect the S17 connector from the television camera assembly.E141014E02

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection (Terminal No.)
    Condition
    Specified Condition
    CB+ (S17-4) - CA+ (F12-24)
    Always
    Below 1 Ω
    CGND (S17-3) - CGND (F12-21)
    Always
    Below 1 Ω
    CV+ (S17-2) - V+ (F12-22)
    Always
    Below 1 Ω
    CV- (S17-1) - V- (F12-23)
    Always
    Below 1 Ω
    CB+ (S17-4) - Body ground
    Always
    10 kΩ or higher
    CGND (S17-3) - Body ground
    Always
    10 kΩ or higher
    CV+ (S17-2) - Body ground
    Always
    10 kΩ or higher
    CV- (S17-1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. INSPECT NAVIGATION RECEIVER ASSEMBLY

  1. Reconnect the navigation receiver F12 connector.E134718E02

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    CB+ (S17-4) - CGND (S17-3)
    Engine switch on (IG)
    Shift lever R position
    5.50 to 7.05 V



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY
OK


3. INSPECT TELEVISION CAMERA ASSEMBLY

  1. Reconnect the television camera assembly S17 connector.E134719E02

  1. E119731E02
    Check the waveform of the television camera assembly using an oscilloscope.

    Standard waveform:
    Tester Connection
    Condition
    Specified Condition
    CV+ (S17-2) - CV- (S17-1)
    Engine switch on (IG)
    Shift lever R position
    Shown in the illustration



NG
REPLACE TELEVISION CAMERA ASSEMBLY
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Reverse Signal Circuit (Oct 2006 – May 2009)PRECAUTION (from Jun 2009) →