TERMINALS OF ECU
System information · Vehicles built Oct 2006 – May 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| A/C AMPLIFIER |
*2: except LHD with the 2AZ-FE
*3: LHD with the 2AZ-FE
*4: for 2GR-FE


- HINT:
- Check from the rear of the connector while it is connected to the A/C amplifier.
| Terminal No. (Symbols) |
Wiring Color |
Terminal Description |
Condition |
Specified Condition |
| E38-1 (IG+) - E38-14 (GND) |
V - W-B |
Power source (IG) |
Ignition switch on (IG) |
10 to 14 V |
| E38-1 (IG+) - E38-14 (GND) |
V - W-B |
Power source (IG) |
Ignition switch off |
Below 1 V |
| E38-2 (SOL+) - E38-14 (GND) |
W - W-B |
A/C compressor operation signal |
Engine is running A/C switch: ON Blower switch: LO |
Pulse generation (See waveform 1) |
| E38-5 (TAM) - E38-14 (GND) |
P - W-B (*2) G - W-B (*3) |
A/C ambient temperature sensor signal |
Ignition switch on (IG) at 25°C (77°F) |
1.35 to 1.75 V |
| E38-5 (TAM) - E38-14 (GND) |
P - W-B (*2) G - W-B (*3) |
A/C ambient temperature sensor signal |
Ignition switch on (IG) at 40°C (104°F) |
0.9 to 1.2 V |
| E38-8 (LOCK)*4 - E38-14 (GND) |
G - W-B |
A/C compressor lock sensor signal |
Engine is running Blower switch: LO A/C switch: ON |
Pulse generation (See waveform 2) |
| E38-9 (PRE) - E38-13 (SG-2) |
V - L |
A/C pressure sensor signal |
Start engine, Operate A/C system, Refrigerant pressure: Abnormal pressure (more than 3,140 kPa (32.0 kgf/cm2, 455 psi)) |
4.74 V or higher |
| E38-9 (PRE) - E38-13 (SG-2) |
V - L |
A/C pressure sensor signal |
Start engine, Operate A/C system, Refrigerant pressure: Abnormal pressure (less than 196 kPa (2.0 kgf/cm2, 28 psi)) |
Below 0.76 V |
| E38-9 (PRE) - E38-13 (SG-2) |
V - L |
A/C pressure sensor signal |
Start engine, Operate A/C system, Refrigerant pressure: Abnormal pressure (more than 3,140 kPa (32.0 kgf/cm2, 455 psi) and less than 196 kPa (2.0 kgf/cm2, 28 psi)) |
0.76 to 4.74 V |
| E38-10 (S5-3) - E38-13 (SG-2) |
BR - L |
Power supply for A/C pressure sensor |
Ignition switch on (IG) A/C switch: ON |
4.5 to 5.5 V |
| E38-10 (S5-3) - E38-13 (SG-2) |
BR - L |
Power supply for A/C pressure sensor |
Ignition switch on (IG) A/C switch: OFF |
Below 1 V |
| E38-11 (CANH) - E38-12 (CANL) |
B - W |
CAN communication system |
CAN communication circuit |
Pulse generation |
| E38-13 (SG-2) - Body ground |
L - Body ground |
Ground for A/C pressure sensor, A/C ambient temperature sensor, A/C lock sensor |
Always |
Below 1 V |
| E38-14 (GND) - Body ground |
W-B - Body ground |
Ground for main power supply |
Always |
Below 1 V |
| E38-20 (MGC)*4 - E38-14 (GND) |
LG - W-B |
A/C compressor magnetic clutch operation signal |
Ignition switch on (IG) Blower switch: LO A/C switch: OFF |
10 to 14 V |
| E38-20 (MGC)*4 - E38-14 (GND) |
LG - W-B |
A/C compressor magnetic clutch operation signal |
Ignition switch on (IG) Blower switch: LO A/C switch: ON |
Below 1 V |
| E38-21 (B) - E38-14 (GND) |
GR - W-B |
Power source (Back-up) |
Always |
10 to 14 V |
| E38-23 (BLW) - E38-14 (GND) |
R - W-B |
Blower motor speed control signal |
Ignition switch on (IG) Blower switch: ON |
Pulse generation (See waveform 3) |
| E38-29 (TR) - E38-34 (SG-1) (*1) |
P - LG |
A/C room temperature sensor signal |
Ignition switch on (IG) Cabin temperature at 25°C (77°F) |
1.8 to 2.2 V |
| E38-29 (TR) - E38-34 (SG-1) (*1) |
P - LG |
A/C room temperature sensor signal |
Ignition switch on (IG) Cabin temperature at 40°C (104°F) |
1.2 to 1.6 V |
| E38-32 (TSP) - E38-14 (GND) (*1) |
Y - W-B |
A/C solar sensor signal (for Front passenger side) |
Ignition switch on (IG) Solar sensor is subjected to electric light. |
0.8 to 4.3 V |
| E38-32 (TSP) - E38-14 (GND) (*1) |
Y - W-B |
A/C solar sensor signal (for Front passenger side) |
Ignition switch on (IG) Solar sensor is covered with a cloth. |
Below 0.8 V |
| E38-33 (TSD) - E38-14 (GND) (*1) |
O - W-B |
A/C solar sensor signal (for Driver side) |
Ignition switch on (IG) Solar sensor is subjected to electric light. |
0.8 to 4.3 V |
| E38-33 (TSD) - E38-14 (GND) (*1) |
O - W-B |
A/C solar sensor signal (for Driver side) |
Ignition switch on (IG) Solar sensor is covered with a cloth. |
Below 0.8 V |
| E38-34 (SG-1) - Body ground (*1) |
LG - Body ground |
Ground for A/C room temperature sensor |
Always |
Below 1 V |
| E38-37 (LIN1) - E38-14 (GND) |
GR - W-B |
LIN communication signal |
Ignition switch on (IG) |
Pulse generation |
| E38-38 (RDFG) - E38-14 (GND) |
G - W-B |
DEF relay signal |
Ignition switch on (IG) REAR DEF switch: ON |
Below 1 V |
| E38-38 (RDFG) - E38-14 (GND) |
G - W-B |
DEF relay signal |
Ignition switch on (IG) REAR DEF switch: OFF |
10 to 14 V |
| e1-2 (BUS G) - Body ground |
- |
Ground for BUS IC |
Always |
Below 1 V |
| e1-3 (BUS) - e1-2 (BUS G) |
- |
BUS IC control signal |
Ignition switch off → on (IG) |
Pulse generation |
| e1-4 (B BUS) - e1-2 (BUS G) |
- |
Power supply for BUS IC |
Ignition switch off |
Below 1 V |
| e1-4 (B BUS) - e1-2 (BUS G) |
- |
Power supply for BUS IC |
Ignition switch on (IG) |
10 to 14 V |
| e1-5 (SGA) - Body ground |
- |
Ground for evaporator temperature sensor |
Always |
Below 1 V |
| e1-6 (TEA) - e1-5 (SGA) |
- |
A/C evaporator temperature sensor signal |
Ignition switch on (IG) Evaporator temperature at 0°C (32°F) |
1.7 to 2.1 V |
| e1-6 (TEA) - e1-5 (SGA) |
- |
A/C evaporator temperature sensor signal |
Ignition switch on (IG) Evaporator temperature at 15°C (59°F) |
0.9 to 1.3 V |
Waveform 1:

Item
Contents
Terminal No. (Symbols)
E38-2 (SOL+) - E38-14 (GND)
Tool Setting
5 V/DIV., 500 μs/DIV.
Vehicle Condition
Engine is running
A/C switch: ON
Blower switch: LO
Waveform 2:

Item
Contents
Terminal No. (Symbols)
E38-8 (LOCK) - E38-14 (GND)
Tool Setting
200 mV/DIV., 10 ms./DIV.
Vehicle Condition
Engine is running
Blower switch: LO
A/C switch: ON
Waveform 3:

Item
Contents
Terminal No. (Symbols)
E38-23 (BLW) - E38-14 (GND)
Tool Setting
1 V/DIV., 500 μs/DIV.
Vehicle Condition
Ignition switch on (IG)
Blower switch: ON
| A/C CONTROL ASSEMBLY |


- HINT:
- Check from the rear of the connector while it is connected to the A/C control assembly.
| Terminal No. (Symbols) |
Wiring Color |
Terminal Description |
Condition |
Specified Condition |
| F16-10 (GND) - Body ground |
W-B - Body ground |
Ground for A/C control assembly |
Always |
Below 1 V |
| F16-9 (TX+) - F16-10 (GND) |
L - W-B |
LIN communication circuit |
Ignition switch on (IG) |
Pulse generation |
| F16-8 (IG+) - F16-10 (GND) |
V - W-B |
Power source (IG) |
Ignition switch off |
Below 1 V |
| F16-8 (IG+) - F16-10 (GND) |
V - W-B |
Power source (IG) |
Ignition switch on (IG) |
10 to 14 V |