2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. EJECT MAP DISC
  1. Turn the ignition switch to the ACC position.

  1. Push the "CLOSE" button.

  1. Touch "MAP EJECT" on the navigation screen to eject the map disc.


2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

  1. B152779
    Turn the shift lever knob counterclockwise and remove the shift lever knob sub-assembly.


3. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

  1. B144599
    Disengage the 2 clips and remove the No. 2 instrument cluster finish panel garnish.


4. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

  1. B144605
    Disengage the 2 clips and remove the No. 1 instrument cluster finish panel garnish.


5. REMOVE POSITION INDICATOR HOUSING ASSEMBLY

  1. B152776E01
    Open the lid of the upper console panel.

  1. Apply protective tape to the area shown in the illustration.

  1. B152777
    Using a moulding remover, disengage the 2 claws and the 5 clips, and then remove the position indicator housing assembly as shown in the illustration.


6. REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY

  1. B144604
    Disengage the 3 claws and the 5 clips, and remove the upper console rear panel sub-assembly.


7. REMOVE LOWER INSTRUMENT CLUSTER FINISH PANEL CENTER SUB-ASSEMBLY

  1. B141243E01
    Remove the 2 screws <F>.

  1. Disengage the 4 claws.

  1. Disconnect each connector and remove the instrument cluster finish panel center sub-assembly.

    HINT:
    Set the shift lever in the D position.


8. REMOVE INSTRUMENT PANEL NO. 2 REGISTER ASSEMBLY

  1. B152782E01
    Apply protective tape to the areas shown in the illustration.

  1. B152783
    Using a moulding remover, disengage the 3 clips.

  1. B152784
    Using a moulding remover, disengage the 4 clips.

  1. Disconnect the connector and remove the instrument panel No. 2 register assembly.


9. REMOVE NAVIGATION RECEIVER WITH HEATER CONTROL PANEL ASSEMBLY

  1. E137564
    Remove the 4 bolts.

  1. Pull the navigation receiver with heater control panel assembly toward the rear of the vehicle and disengage the 4 clips.

  1. Disconnect each connector and remove the navigation receiver with heater control panel assembly.


10. REMOVE RADIO NO. 1 BRACKET

  1. E129206
    Remove the 3 bolts and 2 screws and radio No. 1 bracket.


11. REMOVE RADIO NO. 2 BRACKET

  1. E129207
    Remove the 3 bolts and 2 screws and radio No. 2 bracket.


12. REMOVE NAVIGATION RECEIVER ASSEMBLY

  1. E129208
    Remove the navigation receiver assembly as shown in the illustration.

← COMPONENTS (from Jun 2009)REMOVAL (from Jun 2009) →