2006-2011 Camry Aurion · Service Manual BODY

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009


1. REMOVE NO. 2 ULTRASONIC SENSOR (w/ Clearance Sonar System)
  1. Disconnect each sensor connector.

  1. E206037
    Remove the sensor retainer as shown in the illustration.

  1. E205958
    While pushing down on the lever with a finger to release the claw, disengage the claw on the other side to remove the No. 2 ultrasonic sensor.

    HINT:
    The type of the claws on the top and bottom of the sensor are different. Observe the claws carefully before attempting to remove the sensor.


2. REMOVE NO. 2 ULTRASONIC SENSOR RETAINER (w/ Clearance Sonar System)

  1. E134862
    Disengage the 2 claws and remove the No. 2 ultrasonic sensor retainer from the rear bumper.


3. REMOVE NO. 2 LUGGAGE ROOM WIRE (w/ Clearance Sonar System)

4. REMOVE REAR LOWER SPOILER (w/ Rear Lower Spoiler)

  1. Remove the 2 screws, 4 nuts and 16 clips.

    B137223

  1. Disengage the 16 claws and remove the rear lower spoiler.


5. REMOVE REAR BUMPER EXTENSION LH (w/ Rear Lower Spoiler)

  1. B137222
    Remove the 2 nuts and rear bumper extension LH.


6. REMOVE REAR BUMPER EXTENSION RH (w/ Rear Lower Spoiler)

HINT:
Use the same procedure for the RH side and LH side.


7. REMOVE REAR BUMPER PLATE LH

8. REMOVE REAR BUMPER PLATE RH

9. REMOVE REAR BUMPER PAD

  1. B146333
    Remove the rear bumper pad.

    HINT:
    Use the same procedure for the RH side and LH side.


10. REMOVE REAR BUMPER SIDE SUPPORT LH

  1. B137219
    Remove the 2 screws.

  1. Disengage the 3 claws and remove the rear bumper side support LH.


11. REMOVE REAR BUMPER SIDE SUPPORT RH

HINT:
Use the same procedure for the RH side and LH side.


12. REMOVE REAR BUMPER SIDE RETAINER LH

  1. B137220
    Remove the 2 screws.

  1. Disengage the 3 claws and remove the rear bumper side retainer LH.


13. REMOVE REAR BUMPER SIDE RETAINER RH

HINT:
Use the same procedure for the RH side and LH side.


14. REMOVE WHEEL HOUSE REINFORCEMENT LH

  1. B137221
    Remove the nut and wheel house reinforcement LH.


15. REMOVE WHEEL HOUSE REINFORCEMENT RH

HINT:
Use the same procedure for the RH side and LH side.


16. REMOVE REAR BUMPER REINFORCEMENT SUB-ASSEMBLY

  1. B149452
    Remove the 6 nuts and rear bumper reinforcement sub-assembly.

← DISASSEMBLY (Jun 2006 – May 2009)REASSEMBLY (Jun 2006 – May 2009) →