P0872 Transmission Fluid Pressure Sensor / Switch "C" Circuit Low
Diagnostic trouble codes · Vehicles built from Oct 2006
Also covers:
- P0873 Transmission Fluid Pressure Sensor / Switch "C" Circuit High
DESCRIPTION
ATF pressure switch No. 1 is installed in the shift solenoid valve ATF output passage. This switch is used to identify the malfunctioning part when a fail-safe operation is performed. If the shift solenoid valve malfunctions when the ATF switch has a malfunction, a fail-safe operation will be performed. This fail-safe operation is different from the fail-safe operation performed when the solenoid valve malfunctions and the ATF switch is normal.| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0872 |
ATF pressure switch No. 1 OFF is detected twice when any of the gears from 1st to 4th engages normally. |
|
| P0873 |
ATF pressure switch No. 1 ON is detected twice when 5th or 6th gear engages normally. |
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0872 OR P0873) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the intelligent tester on.
Enter the following items: "Powertrain / ECT / DTC / Current or Pending".
Read the DTCs using the intelligent tester.
- Result:
Display (DTC output)
Proceed to
Only "P0873" is output
A
Only "P0872" is output
B
"P0872 or P0873" and other DTCs are output
C
- HINT:
- If a solenoid is stuck OFF, DTCs for several solenoids including the malfunctioning solenoid will be detected.
|
|
||||
|
|
||||
| A | |
| 2. CHECK TRANSMISSION WIRE (SHORT TO GROUND) |
Remove the TCM.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Condition
Specified Condition
10 (TPS1) - Body ground (Valve body assembly)
10 kΩ or higher
|
|
||||
| NG | |
| 3. CHECK ATF TEMPERATURE SENSOR ASSEMBLY (ATF PRESSURE SWITCH NO. 1) |
Disconnect the connector from the ATF temperature sensor assembly.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Condition
Specified Condition
3 (TPS1) - Body ground (Valve body assembly)
10 kΩ or higher
|
|
||||
| OK | ||
| ||
| 4. CHECK TRANSMISSION WIRE |
Remove the TCM.

Disconnect the speed sensor connector from the ATF temperature sensor assembly.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Condition
Specified Condition
10 (TPS1) - 3 (TPS1)
Below 1 Ω
10 (TPS1) or 3 (TPS1) - Body ground (Valve body assembly)
10 kΩ or higher
|
|
||||
| OK | ||
| ||
