P0989 Transmission Fluid Pressure Sensor / Switch "E" Circuit Low
Diagnostic trouble codes · Vehicles built from Oct 2006
Also covers:
- P0990 Transmission Fluid Pressure Sensor / Switch "E" Circuit High
DESCRIPTION
ATF pressure switch No. 3 is installed in the lockup solenoid ATF output passage and is used to detect a malfunction in the lockup solenoid.| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0989 |
Transmission fluid pressure switch No. 3 is OFF when lock-up occurs in response to a lock-up request (2-trip detection logic). |
|
| P0990 |
When both of the following are detected (2-trip detection logic):
|
MONITOR DESCRIPTION
The TCM illuminates the MIL and stores the DTC when the TCM detects that the ATF pressure switch is OFF with the lock-up solenoid ON or when the TCM detects that the ATF pressure switch is ON with the lock-up solenoid OFF.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0989 OR P0990) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the intelligent tester on.
Enter the following items: "Powertrain / ECT / DTC / Current or Pending".
Read the DTCs using the intelligent tester.
- Result:
Display (DTC output)
Proceed to
Only "P0990" is output
A
Only "P0989" is output
B
"P0989 or P0990" and other DTCs are output
C
- HINT:
- If a solenoid is stuck OFF, DTCs for several solenoids including the malfunctioning solenoid will be detected.
|
|
||||
|
|
||||
| A | |
| 2. CHECK TRANSMISSION WIRE (SHORT TO GROUND) |
Remove the TCM.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Condition
Specified Condition
19 (TPS3) - Body ground (Valve body assembly)
10 kΩ or higher
|
|
||||
| NG | |
| 3. CHECK ATF TEMPERATURE SENSOR ASSEMBLY (ATF PRESSURE SWITCH NO. 3) |
Disconnect the connector from the ATF temperature sensor assembly.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Condition
Specified Condition
5 (TPS3) - Body ground (Valve body assembly)
10 kΩ or higher
|
|
||||
| OK | ||
| ||
| 4. CHECK TRANSMISSION WIRE |
Remove the TCM.

Disconnect the speed sensor connector from the transmission wire.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Condition
Specified Condition
19 (TPS3) - 5 (TPS3)
Below 1 Ω
19 (TPS3) or 5 (TPS3) - Body ground (Valve body assembly)
10 kΩ or higher
|
|
||||
| OK | ||
| ||
