Confirm that the wire harness of the crankshaft position sensor is secured to the wire harness clamp bracket through the back of the rib of the timing chain cover.
Install the generator assembly with the 2 bolts.
Torque:
Bolt A:
21 N*m{
215 kgf*cm
, 16 ft.*lbf
}
Bolt B:
52 N*m{
530 kgf*cm
, 38 ft.*lbf
}
Install the generator wire to terminal B with the nut.
Torque:
9.8 N*m{
100 kgf*cm
, 87 in.*lbf
}
Install the clamp bracket with the bolt.
Torque:
8.4 N*m{
86 kgf*cm
, 74 in.*lbf
}
Attach the clamp and connect the generator connector to the generator.
2.
INSTALL V-RIBBED BELT
Using SST and a 19 mm socket wrench, loosen the V-ribbed belt tensioner arm clockwise, then install the V-ribbed belt.
SST
09216-42010
NOTICE:
Be sure to connect SST and the tools so that they are in line during use.
When retracting the tensioner, turn it clockwise slowly for 3 seconds or more. Do not apply force rapidly.
After the tensioner is fully retracted, do not apply more force than necessary.
After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Check to confirm that the belt has not slipped out of the grooves on the bottom of the crank pulley by hand.