2006-2011 Camry Aurion · Service Manual HEATER & AIR CONDITIONING SYSTEM

REMOVAL

Removal / installation · Vehicles built Jun 2006 – May 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009


1. REMOVE FRONT BUMPER ASSEMBLY (w/ Fog Light)

  1. B150435E01
    Put protective tape around the front bumper assembly.

  1. B138884E01
    Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B150437
    Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.

  1. B150439
    Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect each connector, and then remove the front bumper assembly.


2. REMOVE FRONT BUMPER ASSEMBLY (w/o Fog Light)

  1. B150434E01
    Put protective tape around the front bumper assembly.

  1. B138884E01
    Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B150436
    Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.

  1. B150438
    Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Remove the front bumper assembly.


3. REMOVE AMBIENT TEMPERATURE SENSOR

  1. E128543
    Disconnect the connector and detach the clamp.

  1. Remove the ambient temperature sensor.

← COMPONENTS (from Jun 2006)REMOVAL (from Jun 2009) →