2006-2011 Camry Aurion · Service Manual HEATER & AIR CONDITIONING SYSTEM

REMOVAL

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Turn the A/C switch on.

  1. Operate the cooler compressor at an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant. This causes most of the compressor oil from the various components of the A/C system to collect in the A/C compressor.

  1. Stop the engine.

  1. Recover the refrigerant from the A/C system using a refrigerant recovery unit.


2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

  1. A144946E01
    Disconnect the mass air flow meter connector (*1).

  1. Disconnect the purge VSV connector (*2).

  1. Disconnect the 2 purge VSV vacuum hoses (*3).

  1. Disconnect the purge line hose from the clamp (*4).

  1. A146036
    Disconnect the No. 2 ventilation hose from the air cleaner hose.

  1. A135668
    Lock the No. 1 air cleaner hose clamp, and then disconnect the No. 1 air cleaner hose from the throttle body.

  1. A146037
    Remove the 2 bolts and air cleaner cap.

  1. Remove the air cleaner filter element from the air cleaner case.


3. REMOVE AIR CLEANER INLET ASSEMBLY

  1. A134903
    Remove the 2 bolts, clamp and air cleaner inlet.


4. REMOVE FRONT BUMPER ASSEMBLY

  1. B220943E01
    Put protective tape around the front bumper assembly.

  1. B138884E01
    Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B220944
    Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.

  1. B220945
    Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. w/o Fog Light:

    1. Remove the front bumper assembly.

  1. w/ Fog Light:

    1. Disconnect each connector, and then remove the front bumper assembly.


5. REMOVE FRONT BUMPER ENERGY ABSORBER

  1. B220950E01
    Disengage the 2 guides and remove the front bumper energy absorber from the front bumper reinforcement sub-assembly.


6. SEPARATE RADIATOR RESERVOIR TANK HOSE

  1. A135233
    Separate the radiator reserve tank hose from the radiator assembly.


7. REMOVE HOOD LOCK ASSEMBLY (for LHD)

  1. B149051
    Remove the 3 bolts.

  1. B136827
    Disconnect the hood lock control cable.

  1. Remove the hood lock assembly.


8. REMOVE HOOD LOCK ASSEMBLY (for RHD)

  1. B149052
    Disconnect the connector.

  1. Remove the 3 bolts.

  1. B149053
    Disconnect the hood lock control cable.

  1. Remove the hood lock assembly.


9. REMOVE RADIATOR SUPPORT UPPER
  1. Remove the clamp and separate the hood lock control cable from the radiator support upper.

  1. A145802
    Remove the 5 bolts and radiator support upper.


10. REMOVE HOOD LOCK SUPPORT SUB-ASSEMBLY

  1. E129983
    Remove the bolt and hood lock support sub-assembly.


11. DISCONNECT AIR CONDITIONING TUBE AND ACCESSORY

  1. E128544
    Remove the bolt and disconnect the air conditioning tube and accessory from the condenser.

  1. Remove the O-ring from the air conditioning tube and accessory.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.


12. DISCONNECT COOLER REFRIGERANT DISCHARGE PIPE

  1. E128545
    Remove the bolt and disconnect the cooler refrigerant discharge pipe from the condenser.

  1. Remove the O-ring from the cooler refrigerant discharge pipe.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.


13. REMOVE COOLER CONDENSER ASSEMBLY

  1. E129141
    Remove the 4 bolts and condenser.


14. REMOVE COOLER DRYER

  1. E101931
    Using a 14 mm straight hexagon wrench, remove the cap from the modulator.

  1. E050386
    Using pliers, remove the cooler dryer.

← REMOVAL (Oct 2006 – May 2009)INSTALLATION (Jun 2006 – Sep 2006) →