2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Power Source Circuit

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

This circuit is the power source for the clock assembly. This circuit provides two types of power sources; one is a constant power source mainly used as a backup power source, and the other is a power source mainly used for signal transmission. The constant power source is mainly used as a backup power source of the clock assembly.

HINT:
If the clock assembly displays "1:00" when the ignition switch is turned off, and turned on (IG) position again, the B terminal has a malfunction.


WIRING DIAGRAM

E132651E05

INSPECTION PROCEDURE


1. INSPECT CLOCK ASSEMBLY

  1. E134476E01
    Disconnect the F3 connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    F3-1 (B) - Body ground
    Always
    10 to 14 V
    F3-2 (ACC) - Body ground
    Ignition switch on (ACC or IG)
    10 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    F3-11 (GND1) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE


← Speed Signal Circuit (from Jun 2009)PRECAUTION (from Jun 2006) →