2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009


1. REMOVE NO. 2 HEADLIGHT BULB

  1. E192190
    Remove the No. 2 headlight bulb as shown in the illustration.


2. REMOVE NO. 1 HEADLIGHT BULB
  1. Disconnect the headlight socket cover.

  1. E192590
    Remove the No. 1 headlight bulb and headlight bulb socket as shown in the illustration.

  1. Disconnect the connector.

  1. Remove the No. 1 headlight bulb from the headlight bulb socket.


3. REMOVE FRONT TURN SIGNAL LIGHT BULB

  1. E192192
    Turn the front turn signal light bulb and front turn signal light socket in the direction indicated by the arrow shown in the illustration and remove them as a unit.

  1. Remove the front turn signal light bulb from the front turn signal light socket.


4. REMOVE CLEARANCE LIGHT BULB

  1. E192194
    Turn the clearance light bulb and clearance light socket in the direction indicated by the arrow shown in the illustration and remove them as a unit.

  1. Remove the clearance light bulb from the clearance light socket.


5. REMOVE HEADLIGHT LEVELING MOTOR (w/ Headlight Leveling)

  1. E192196
    Align the notches of the headlight leveling motor and housing, and pull out the headlight leveling motor slightly.

  1. Lower the tip of the headlight leveling motor to disengage it from the reflector and remove the headlight leveling motor.


6. REMOVE HEADLIGHT LEVELING MOTOR BASE PACKING (w/ Headlight Leveling)
  1. Remove the headlight leveling motor base packing.

    NOTICE:
    After the headlight leveling motor base packing is removed, be sure to replace it with a new one. Failure to do this may cause water ingress.

← DISASSEMBLY (Jun 2006 – May 2009)ADJUSTMENT (Jun 2006 – May 2009) →