Disengage the 2 clips and remove the front door lower frame bracket garnish.
2.
REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG
Using a screwdriver with the tip wrapped with protective tape, disengage the 3 claws, and remove the front door inside handle bezel plug.
3.
REMOVE ASSIST GRIP COVER
Using a screwdriver with the tip wrapped with protective tape, disengage the 6 claws and remove the assist grip cover.
4.
REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
Remove the 3 screws and clip (A).
Using a clip remover, disengage the 9 clips.
Pull up the front door trim board in the direction indicated by the arrow.
Disengage the reference bosses from the front door panel.
Raise the front door trim board to disengage the 4 claws and remove the front door trim board together with the front door inner glass weatherstrip.
Disengage the 2 claws and disconnect the front door inside handle sub-assembly.
5.
REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP
Using a screwdriver, disengage the 4 clips as shown in the illustration and remove the front door inner glass weatherstrip from the front door trim board.
6.
REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
Disconnect the connector.
Remove the 3 screws and the power window regulator master switch assembly.