2006-2011 Camry Aurion · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

  1. B136443E01
    Using a screwdriver with the tip wrapped with protective tape, disengage the 3 claws and remove the rear door inside handle bezel plug.


2. REMOVE DOOR ASSIST GRIP COVER

  1. B149028E01
    Using a screwdriver with the tip wrapped with protective tape, disengage the 6 claws and remove the door assist grip cover.


3. REMOVE REAR ASH RECEPTACLE ASSEMBLY (w/ Ashtray)

  1. B136442
    Remove the rear ash receptacle assembly.


4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

  1. B136451
    Remove the 3 screws.

  1. Using a clip remover, disengage the 7 clips.

  1. B136452
    Raise the rear door trim board to disengage the 4 claws and remove the rear door trim board together with the rear door inner glass weatherstrip.

  1. Disconnect the connector.

  1. B136453
    Disengage the 2 claws and disconnect the rear door inside handle sub-assembly.

  1. B141704
    Disengage the clip as shown in the illustration and remove the No. 1 door scuff plate clamp from the rear door trim board.


5. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP

  1. B136456
    Disengage the 3 clips as shown in the illustration and remove the rear door inner glass weatherstrip from the rear door trim board.


6. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY

  1. B136457
    Using a screwdriver with the tip wrapped with protective tape, disengage the 2 claws and remove the rear power window regulator switch assembly.

← COMPONENTS (from Oct 2006)REMOVAL (Oct 2006 – May 2009) →