DIAGNOSTIC TROUBLE CODE CHART
Diagnostic trouble codes · Vehicles built from Jun 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
- HINT:
- Parameters listed in the chart may be different from your readings depending on the type of instruments used and other factors.
- If any DTCs are displayed during a check mode, check the circuit for the DTCs listed below. For details of each DTC, refer to the page indicated.
- Parameters listed in the chart may be different from your readings depending on the type of instruments used and other factors.
| DTC Code |
Detection Item |
Trouble Area |
See page |
| U0182 |
Lost Communication with AFS ECU |
1. AFS ECU power source circuit 2. AFS ECU 3. AFS ECU branch wire or connector |
Click here
|
| U1002 |
Lost Communication with Gateway Module |
1. Open or short in CAN No. 2 main bus wire or connector 2. Open or short in CAN No. 2 branch wire or connector 3. CAN No. 2 J/C 4. Gateway ECU 5. AFS ECU |
Click here
|
- HINT:
- When communication with the ECUs connected to the CAN No. 2 bus is interrupted or a malfunction in the CAN No. 2 bus occurs, the gateway ECU detects the malfunctions and outputs DTCs.
| DTC Code |
Detection Item |
Trouble Area |
See page |
| B1207 |
Certification ECU Communication Malfunction |
1. Certification ECU power source circuit 2. Certification ECU 3. Certification ECU main wire or connector |
Click here
|
| B1297 |
Clearance Sonar ECU Communication Stop |
1. Clearance warning ECU power source circuit 2. Clearance warning ECU 3. Clearance warning ECU branch wire or connector |
Click here
|
| B2326 |
CAN MS Bus Line Communication Malfunction |
1. Open or short in CAN MS bus main wire or connector 2. Open or short in CAN MS bus branch wire or connector 3. Certification ECU 4. Clearance warning ECU 5. Main body ECU 6. CAN No. 3 J/C |
Click here
|
- HINT:
- When communication with the ECUs connected to the CAN MS bus is interrupted or a malfunction in the CAN MS bus occurs, the main body ECU detects the malfunctions and outputs DTCs.