INSPECTION
Inspection · Vehicles built from Oct 2006
| INSPECT COMPRESSOR AND MAGNETIC CLUTCH (A/C LOCK SENSOR) |
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
1 - 2
Always
(at 20°C (68°F))
160 to 320 Ω
| INSPECT COMPRESSOR AND MAGNETIC CLUTCH (A/C COMPRESSOR SOLENOID) |
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
2 - 1
20°C (68°F)
10 to 11 Ω
| INSPECT COMPRESSOR AND MAGNETIC CLUTCH |
Disconnect the connector from the compressor and magnetic clutch.

Disconnect the connector from the magnetic clutch.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
A-3 - B-1
Always
Below 1 Ω
A-3 - Body ground
Always
10 kΩ or higher
| INSPECT MAGNETIC CLUTCH |
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
1 - Body ground
20 °C (68°F)
3.8 to 4.2 Ω
When connector terminal 1 is connected to the positive (+) battery terminal, check that the following occurs: 1) the magnetic clutch's operating sound can be heard, and 2) the magnetic clutch's hub and rotor lock.
- OK:
- 1):
- The magnetic clutch's operating sound can be heard.
- 2):
- The magnetic clutch's hub and rotor lock.
