2006-2011 Camry Aurion · Service Manual ENGINE

P0660 Intake Manifold Tuning Valve Control Circuit / Open (Bank 1)

Diagnostic trouble codes · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

This circuit opens and closes the Intake Air Control Valve (IACV) in response to changes in the engine load in order to increase the intake efficiency (ACIS: Acoustic Control Induction System).
When the engine speed is between 0 and 4,450 rpm and the throttle valve opening angle is 60° or more, the ECM supplies current to the VSV (ON status), to close the IACV. Under other conditions, the VSV is usually OFF and the IACV is open.
G041080E05
DTC No.
DTC Detection Condition
Trouble Area
P0660
The following conditions are met simultaneously for 0.5 seconds or more (2 trip detection logic):
  1. Voltage of terminal ACIS of the ECM is low when the VSV is OFF
  2. The engine has been started
  1. Open or short in intake manifold tuning valve control circuit
  2. Surge tank (intake air control valve)
  3. ECM

WIRING DIAGRAM

A138547E01

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Start the engine and turn the tester on.

  1. Select the following menu items: Powertrain / Engine / Active Test / Active the VSV for Intake Control.

  1. Check if operating noise can be heard when operating the air intake control valve using the intelligent tester.

    Result:
    Result
    Proceed to
    NG
    A
    OK (When troubleshooting in accordance with the DTC CHART)
    B
    OK (When troubleshooting in accordance with the PROBLEM SYMPTOMS TABLE)
    C



B
CHECK FOR INTERMITTENT PROBLEMS

C
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
A


2. CHECK INTAKE AIR CONTROL VALVE (OPERATION)

  1. A095664E05
    Disconnect the C48 air intake valve connector.

  1. Apply battery voltage between the terminals of the intake air control valve connector.

  1. Check intake air control valve operation.

    OK:
    Operating noise can be heard.



NG
REPLACE INTAKE AIR CONTROL VALVE
OK


3. CHECK HARNESS AND CONNECTOR

  1. A137082E09
    Check the wire harness and connectors between the VSV for ACIS and ECM.
    1. Disconnect the C48 VSV for ACIS connector.

    2. Disconnect the C58 (RHD) or C55 (LHD) ECM connector.

    3. Measure the resistance between the terminals of the VSV for ACIS connector and ECM connector.

      Standard resistance (Check for open):
      RHD:
      Tester Connection
      Specified Condition
      VSV for ACIS (C48-1) - ACIS (C58-107)
      Below 1 Ω
      LHD:
      Tester Connection
      Specified Condition
      VSV for ACIS (C48-1) - ACIS (C55-107)
      Below 1 Ω


      Standard resistance (Check for short):
      RHD:
      Tester Connection
      Specified Condition
      VSV for ACIS (C48-1) or ACIS (C58-107) - Body ground
      10 kΩ or higher
      LHD:
      Tester Connection
      Specified Condition
      VSV for ACIS (C48-1) or ACIS (C55-107) - Body ground
      10 kΩ or higher

    4. Reconnect the VSV for ACIS connector.

    5. Reconnect the ECM connector.

  1. Check the EFI No. 3 fuse.

    1. Remove the EFI No. 3 fuse from the engine room R/ B.

    2. Measure the EFI No. 3 fuse resistance.

      Standard resistance:
      Below 1 Ω

    3. Reinstall the EFI No. 3 fuse.

  1. Check the wire harness between the VSV for ACIS connector and EFI MAIN relay.

    1. Remove the engine room junction block from the engine room R/B.

    2. Disconnect the C48 VSV connector.

    3. Measure the resistance between the terminals.

      Standard resistance:
      Check for open:
      Tester Connection
      Specified Condition
      VSV for ACIS (C48-2) - 1E-6
      Below 1 Ω

    4. Reinstall the engine room junction block.

    5. Reinstall the VSV connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)


← P0617 Starter Relay Circuit High (from Jun 2009)P0660 Intake Manifold Tuning Valve Control Circuit / Open (Bank 1) (from Jun 2009) →