2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Clock Loses or Gains Time

Circuit diagnosis · Vehicles built from Jun 2006

DESCRIPTION

Clock assembly receives time (Hour and Minute) adjust signals from the hazard warning switch. The whole hazard warning switch should be replaced if the time adjust button has a malfunction because this part is not independently supplied.

HINT:
  1. The maximum clock assembly margin of error is -4 to 4 seconds per day when the temperature is between -20°C (-4°F) and 60°C (140°F).
  2. If the clock assembly error is greater than specified above, replace the clock assembly.


WIRING DIAGRAM

E134520E01

INSPECTION PROCEDURE


1. INSPECT HAZARD WARNING SWITCH
  1. Remove the hazard warning switch.

  1. E132656E05
    Measure the resistance according to the value(s) in the table below.

    Standard resistance for LHD:
    Tester Connection
    Condition
    Specified Condition
    F4-1 (A/B) - F4-5 (E)
    H switch is not pressed
    10 kΩ or higher
    H switch is pressed
    Below 1 Ω
    F4-2 (RSET) - F4-5 (E)
    M switch is not pressed
    10 kΩ or higher
    M switch is pressed
    Below 1 Ω
    F4-3 (T) - F4-5 (E)
    :00 switch is not pressed
    10 kΩ or higher
    :00 switch is pressed
    Below 1 Ω

    Standard resistance for RHD:
    Tester Connection
    Condition
    Specified Condition
    F4-1 (A/B) - F4-5 (E)
    Arrow down switch is not pressed
    10 kΩ or higher
    Arrow down switch is pressed
    Below 1 Ω
    F4-2 (RSET) - F4-5 (E)
    Arrow up switch is not pressed
    10 kΩ or higher
    Arrow up switch is pressed
    Below 1 Ω
    F4-3 (T) - F4-5 (E)
    MODE switch is not pressed
    10 kΩ or higher
    MODE switch is pressed
    Below 1 Ω



NG
REPLACE HAZARD WARNING SWITCH
OK


2. CHECK HARNESS AND CONNECTOR (CLOCK ASSEMBLY - HAZARD WARNING SWITCH)

  1. E132664E07
    Disconnect F3 and F4 connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    F3-5 (A/B) - F4-1 (A/B)
    Always
    Below 1 Ω
    F3-6 (RSET) - F4-2 (RSET)
    Always
    Below 1 Ω
    F3-7 (ET2) - F4-3 (T)
    Always
    Below 1 Ω
    F3-20 (E) - F4-5 (E)
    Always
    Below 1 Ω
    F3-5 (A/B) - Body ground
    Always
    10 kΩ or higher
    F3-6 (RSET) - Body ground
    Always
    10 kΩ or higher
    F3-7 (ET2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CLOCK ASSEMBLY


← INSTALLATION (from Jun 2009)Clock Display Circuit (Jun 2006 – Sep 2006) →