2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Clock Loses or Gains Time

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

Clock assembly receives time (Hour and Minute) adjust signals from the hazard warning switch. The whole hazard warning switch should be replaced if the time adjust button has a malfunction because this part is not independently supplied.

HINT:
  1. The maximum clock assembly margin of error is -4 to 4 seconds per day when the temperature is between -20°C (-4°F) and 60°C (140°F).
  2. If the clock assembly error is greater than specified above, replace the clock assembly.


WIRING DIAGRAM

E132665E03

INSPECTION PROCEDURE


1. INSPECT HAZARD WARNING SWITCH
  1. Remove the hazard warning switch.

  1. E132656E02
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    F4-1 (A/B) - F4-5 (E)
    H switch is not pressed
    10 kΩ or higher
    H switch is pressed
    Below 1 Ω
    F4-2 (RSET) - F4-5 (E)
    M switch is not pressed
    10 kΩ or higher
    M switch is pressed
    Below 1 Ω



NG
REPLACE HAZARD WARNING SWITCH
OK


2. CHECK HARNESS AND CONNECTOR (CLOCK ASSEMBLY - HAZARD WARNING SWITCH)

  1. E143785E02
    Disconnect F3 and F4 connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    F3-6 (A/B) - F4-1 (A/B)
    Always
    Below 1 Ω
    F3-7 (RSET) - F4-2 (RSET)
    Always
    Below 1 Ω
    F3-12 (E) - F4-5 (E)
    Always
    Below 1 Ω
    F3-6 (A/B) - Body ground
    Always
    10 kΩ or higher
    F3-7 (RSET) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CLOCK ASSEMBLY


← INSTALLATION (from Jun 2009)Clock Display Circuit (Oct 2006 – May 2009) →