2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. INSTALL REAR COMBINATION LIGHT ASSEMBLY

  1. E134244
    Engage the 2 clips.

  1. Install the rear combination light assembly with the 3 screws.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. E134245E01
    Connect the connectors and clamp.


2. INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER LH

  1. B149050
    Install the luggage compartment inner trim cover LH with the 2 clips.


3. INSTALL REAR BUMPER ASSEMBLY (w/o Clearance Sonar System)

  1. without Rear Lower Spoiler:

    1. B149450
      Engage each claw.

    2. Install the rear bumper assembly with the 6 screws and 2 clips.

    3. B149449
      Install the 2 rear bumper plates.

  1. with Rear Lower Spoiler:

    1. B160685
      Engage each claw.

    2. Install the rear bumper assembly with the 6 screws.

    3. B160686
      Install the 2 rear bumper plates.


4. INSTALL REAR BUMPER ASSEMBLY (w/ Clearance Sonar System)

  1. without Rear Lower Spoiler:

    1. Engage each No. 2 luggage room wire clamp to the rear bumper reinforcement sub-assembly.

    2. B149446
      Install the grommet.

    3. Connect the connector.

    4. B149450
      Engage each claw.

    5. Install the rear bumper assembly with the 6 screws and 2 clips.

    6. B149449
      Install the 2 rear bumper plates.

  1. with Rear Lower Spoiler:

    1. Engage each No. 2 luggage room wire clamp to the rear bumper reinforcement sub-assembly.

    2. B149446
      Install the grommet.

    3. Connect the connector.

    4. B160685
      Engage each claw.

    5. Install the rear bumper assembly with the 6 screws.

    6. B160686
      Install the 2 rear bumper plates.


5. INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER RH (w/ Clearance Sonar System)

  1. B136855
    Install the luggage compartment inner trim cover RH with the 2 clips.


6. INSTALL REAR FLOOR FINISH PLATE

  1. B136852
    Engage the 7 clips and install the rear floor finish plate.


7. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

  1. B136879
    Install the 2 No. 1 luggage compartment trim hooks with the 2 screws.


8. INSTALL SPARE WHEEL COVER ASSEMBLY

9. INSTALL SPARE WHEEL COVER CLAMP

10. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

11. INSTALL REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY LH (w/o Rear Lower Spoiler)

  1. B137209
    Install the rear quarter panel mudguard sub-assembly LH with the 3 screws.


12. INSTALL REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY RH (w/o Rear Lower Spoiler)

HINT:
Use the same procedure for RH and LH side.


13. INSTALL REAR FLOOR BOARD (w/ Rear Lower Spoiler)

  1. B138885E01
    Install the rear floor board with the 3 nuts, 2 clips and 4 screws.


14. INSTALL REAR LIGHT ASSEMBLY

  1. E133813E01
    Install the rear light assembly with the 4 nuts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Connect the connector and clamp.


15. INSTALL LUGGAGE COMPARTMENT DOOR COVER

  1. B135465
    Install the luggage compartment door cover with the 13 clips.

← REASSEMBLY (from Jun 2009)INSTALLATION (from Jun 2009) →