2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. INSTALL TURN SIGNAL FLASHER ASSEMBLY

  1. E128235E01
    Install the clamp and the turn signal flasher assembly.

  1. Connect the connector.


2. INSTALL COMBINATION METER ASSEMBLY

  1. E141570
    Connect the 2 connectors as shown in the illustration.

  1. Secure the wire harness to the combination meter assembly.

  1. E141571
    Install the combination meter assembly as shown in the illustration.

  1. E141567
    Install the 4 screws.


3. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

  1. E141566E01
    Engage the guide and the 4 claws.

  1. Install the instrument cluster finish panel sub-assembly with the 2 clips.


4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Smart Entry and Start System)

  1. B158917
    Engage the 2 claws and 2 clips to install the lower instrument panel finish panel.


5. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/ Smart Entry and Start System)
  1. Connect the connector.

  1. B158918
    Engage the 2 claws and 2 clips to install the lower instrument panel finish panel.


6. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY
  1. Connect each connector.

  1. B158916
    Engage the 3 claws and 2 clips to install the No. 1 instrument panel sub-assembly.


7. INSTALL STEERING COLUMN COVER

  1. E141565
    Engage the claw and install the upper steering column cover.

  1. E141563
    Engage the 2 claws.

  1. Install the lower steering column cover with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }


8. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
  1. Install the air hose and connect the connector.

  1. B158913
    Engage the claw and the 4 clips.

  1. Connect the hood lock control cable assembly.

  1. Engage the 2 claws and connect the connector.

  1. Install the lower No. 1 instrument panel finish panel with the screw and bolt.


9. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:
Use the same procedure for the RH side and the LH side (Click here).


10. INSTALL FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedure for the RH side and the LH side (Click here).

← INSTALLATION (Oct 2006 – May 2009)COMPONENTS (Oct 2006 – May 2009) →