INSTALLATION
Removal / installation · Vehicles built from Jun 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
| 1.
INSTALL NETWORK GATEWAY ECU |
 |
- Install the network gateway ECU with the nut.
- Connect the connector.
- Install the wire harness clamp bracket with ECU with the bolt and 2 nuts.
-
Torque:
- 8.0 N*m{
82 kgf*cm
, 71 in.*lbf
}
| 2.
INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
|
 |
- Install the air hose and connect each connector.
Engage the claw and the 4 clips.
Engage the 2 claws and the DLC3.
Install the lower No. 1 instrument panel finish panel with the screw <F> and bolt <D>.
| 3.
INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH |
 |
- HINT:
- Use the same procedure for the RH side and the LH side (Click here).
| 4.
INSTALL FRONT DOOR SCUFF PLATE RH |
 |
- HINT:
- Use the same procedure for the RH side and the LH side (Click here).