2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

REMOVAL

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. REMOVE FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedure for the RH side and the LH side (Click here).


2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:
Use the same procedure for the RH side and the LH side (Click here).


3. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

  1. B158913E01
    Remove the bolt <D> and the screw <F>.

  1. Disengage the 2 claws and the DLC3.

  1. Disconnect the hood lock control cable assembly.

  1. Disengage the claw and the 4 clips.

  1. Remove the air hose, disconnect each connector, and then remove the lower No. 1 instrument panel finish panel.


4. REMOVE NETWORK GATEWAY ECU

  1. E142479
    Remove the 2 nuts and the bolt and disengage the wire harness clamp bracket with ECU.

  1. E142480
    Turn the wire harness clamp bracket with ECU in the direction indicated by the arrow.

    NOTICE:
    Do not apply excessive force.

  1. E142481
    Disconnect the connector.

  1. E142482
    Remove the nut and network gateway ECU.

← REMOVAL (Oct 2006 – May 2009)INSTALLATION (Oct 2006 – May 2009) →