2006-2011 Camry Aurion · Service Manual RESTRAINTS

INSTALLATION

Removal / installation · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. INSTALL SIDE AIRBAG SENSOR
  1. Check that the ignition switch is off.

  1. Check that the battery negative (-) cable is disconnected.

    CAUTION:
    Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.

  1. C133888
    Install the side airbag sensor with the bolt.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    NOTICE:
    1. If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
    1. When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

  1. Check that there is no looseness in the installation parts of the side airbag sensor.

  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.


2. INSTALL LOWER CENTER PILLAR GARNISH

  1. B132058
    Engage the 2 claws and 2 clips, then install the lower center pillar garnish LH.


3. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP

  1. B132081E01
    Install the front door opening trim weatherstrip LH as shown in the illustration.

    NOTICE:
    After installation, check that the corners fit correctly.


4. INSTALL FRONT DOOR SCUFF PLATE

  1. B132067
    Engage the 7 claws and 3 clips, then install the front door scuff plate LH.


5. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP

  1. B132080E02
    Install the rear door opening trim weatherstrip LH as shown in the illustration.

    NOTICE:
    After installation, check that the corners fit correctly.


6. INSTALL REAR DOOR SCUFF PLATE

  1. B132068
    Engage the 5 claws and 2 clips, then install the rear door scuff plate LH.


7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

8. INSPECT SRS WARNING LIGHT
  1. Inspect the SRS warning light (Click here).

← REMOVAL (from Jun 2009)INSTALLATION (Oct 2006 – May 2009) →