2006-2011 Camry Aurion · Service Manual RESTRAINTS

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


INSPECT SIDE AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)
  1. Perform a diagnostic system check (Click here).


INSPECT SIDE AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)
  1. Perform a diagnostic system check (Click here).

  1. When the center pillar of the vehicle or its area is damaged, check if there is any damage to the side airbag sensor. If there are any defects as mentioned below, replace the side airbag sensor with a new one:

    1. Cracks, dents or chips on the sensor housing.
    1. Cracks or other damage to the connector.
    1. Peeling off of the label or damage to the serial number.

    CAUTION:
    Be sure to follow the correct removal and installation procedure.


INSPECT SIDE AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS DEPLOYED)
  1. Replace the side airbag sensor.

    CAUTION:
    Be sure to follow the correct removal and installation procedure.

    HINT:
    The side airbag sensor on the impacted side should be replaced after the front seat airbag assembly and curtain shield airbag assembly have deployed.

← ON-VEHICLE INSPECTION (Oct 2006 – May 2009)REMOVAL (Jun 2006 – Sep 2006) →