2006-2011 Camry Aurion · Service Manual BODY

ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

The driver side position control ECU is contained in the front power seat switch RH.
During manual operation, only one switch signal is accepted. If signals are input from 2 or more switches simultaneously, all of them are ignored, except when signals are input from the front vertical switch and lifter switch simultaneously. In this case, the signal from the lifter switch will be accepted.
During automatic operation, a manual switch input will override any other operations, i.e. automatic operations will stop and the manual input operation only will be performed. For example, if a manual switch input is activated during a seat store/restore operation, the previous operation will cease and manual operation will be performed. After the manual operation is performed, the previous automatic operation will not resume.
The power mirror store/restore operation is not affected by manual switch inputs.
The front power seat switch does not allow the restore operation of the power seat when the system detects that the voltage of terminal SYSB is less than 8.0 +- 0.5 V for 30 msec. or more than 10 +- 0.5 V for 30 msec.
This circuit is the power source circuit for the front power seat switch RH (position control ECU).

HINT:
  1. Manual adjustment of the slide, reclining, or lumbar can be performed even when the front power seat switch RH is not functional if current is allowed to flow into terminals +B and SYSB.
  2. Lumbar support operation and leg support operation can be performed at all times.


WIRING DIAGRAM

B149643E02

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (POSITION CONTROL ECU POWER SOURCE CIRCUIT)

  1. B128716E20
    Disconnect the front power seat switch RH (position control ECU) connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    T20-5 (+B) - Body ground
    Always
    10 to 14 V
    T21-4 (IG) - Body ground
    Engine switch on (IG)
    10 to 14 V
    Engine switch off
    Below 1 V
    T21-8 (SYSB) - Body ground
    Always
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
OK


2. CHECK HARNESS AND CONNECTOR (POSITION CONTROL ECU GROUND CIRCUIT)

  1. B085084E14
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    T20-1 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (GROUND CIRCUIT)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Memory Switch Circuit (from Jun 2009)PARTS LOCATION (from Jun 2006) →