2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Clearance Warning Buzzer Circuit

Circuit diagnosis · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The clearance warning buzzer sounds using pulse signals sent from the clearance warning ECU assembly. The buzzer sounds to alert the driver and the buzzer frequency changes depending on the distance to an obstacle.

WIRING DIAGRAM

B139296E02

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - CLEARANCE WARNING BUZZER)

  1. B139279E05
    Disconnect the O30 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    O30-10 (BBZ) - F30-1
    Always
    Below 1 Ω
    O30-11 (EF) - F30-2
    Below 1 Ω
    O30-10 (BBZ) - Body ground
    10 kΩ or higher
    O30-11 (EF) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. INSPECT CLEARANCE WARNING BUZZER

  1. B139281E01
    Remove the clearance warning buzzer (Click here).

  1. Apply battery voltage and check the operation of the warning buzzer, as shown in the table below.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    Operating sound occurs

    HINT:
    The clearance warning buzzer does not sound when battery voltage is not applied because the buzzer is a separately-excited type.



NG
REPLACE CLEARANCE WARNING BUZZER (Click here)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Clearance Warning Buzzer Circuit (Oct 2006 – May 2009)Clearance Warning ECU Power Source Circuit (Oct 2006 – May 2009) →