2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Oct 2006


INSPECT HEADLIGHT CLEANER CONTROL RELAY (w/ Headlight Cleaner System)

  1. E194796E01
    Inspect headlight cleaner control relay operation.

    1. Measure the resistance between terminals A39-4 (E) and A39-6 (PB).

    2. Connect the positive (+) battery lead to terminal A39-3 (IG) of the connector, and the negative (-) battery lead to terminal A39-4 (E).

    3. Connect the negative (-) battery lead to terminals A39-1 (HDLO) and A39-2 (H), and measure the resistance between terminals A39-4 (E) and A39-6 (PB).

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      A39-4 (E) - A39-6 (PB)
      Always
      10 kΩ or higher
      A39-4 (E) - A39-6 (PB)
      When applying battery voltage
      Below 1 Ω
      A39-4 (E) - A39-6 (PB)
      0.8 to 0.9 seconds after applying battery voltage
      10 kΩ or higher

    4. Disconnect the negative (-) battery lead from terminal A39-1 (HDLO) and A39-2 (H).

    5. Disconnect the positive (+) battery lead from terminal A39-3 (IG), and then reconnect it.

    6. B109906E10
      Connect the negative (-) battery lead to terminals A39-1 (HDLO) and A39-5 (FRWA), and measure the resistance between terminals A39-4 (E) and A39-6 (PB).

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      A39-4 (E) - A39-6 (PB)
      When applying battery voltage
      Below 1 Ω
      A39-4 (E) - A39-6 (PB)
      0.8 to 0.9 seconds after applying battery voltage
      10 kΩ or higher

← REMOVAL (from Jun 2009)INSTALLATION (Oct 2006 – May 2009) →