Circuit diagnosis · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009from Jun 2009
DESCRIPTION
The clock assembly receives the vehicle speed signal from the combination meter.
HINT:
A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter. The signal is changed to a pulse signal at the transistor in the combination meter. Each ECU controls the respective system based on the pulse signal.
If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. CHECK COMBINATION METER SYSTEM
The circuits that send vehicle speed signals to this system are inspected in the meter system (Click here).
During inspection for the meter section, if there is an instruction that indicates to go back inspections for each system, proceed to the next step.
NEXT
2. CHECK HARNESS AND CONNECTOR (CLOCK ASSEMBLY - COMBINATION METER)
Disconnect the F2 and F3 connectors.
Measure the resistance according to the value(s) in the table below.