Navigation Receiver Assembly Power Source Circuit
Circuit diagnosis · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
This is the power source circuit to operate the navigation receiver assembly.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT NAVIGATION RECEIVER ASSEMBLY |
Disconnect the F36 navigation receiver assembly connector.
Disconnect the F13 navigation receiver assembly connector.
Measure the resistance according to the value(s) in the table below .
- Standard Resistance:
Tester Connection
Condition
Specified Condition
F36-7 (GND) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
F36-4 (B) - F36-7 (GND)
Always
11 to 14 V
F36-3 (ACC) - F36-7 (GND)
Ignition switch on (ACC)
11 to 14 V
F13-2 (IG) - F36-7 (GND)
Ignition switch on (IG)
11 to 14 V
|
|
||||
| OK | ||
| ||
