DATA LIST / ACTIVE TEST
System information · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 from Oct 2006
| READ DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows values or status of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Warm up the engine.
Turn the ignition switch to the OFF position.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester on.
Enter the following menus: Diagnosis / Body / Main body / Data list.
Read the Data List according to the display on the tester.
Main Body ECU Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Communication D-Door Motor
Connection status between power window regulator motor (Driver side) and main body ECU (Instrument panel junction block assembly) / OK or STOP
OK: Connection
STOP: No connection
DTC is output if an error occurs in LIN communication
Communication Sliding Roof*
Connection status between sliding roof ECU (Sliding roof drive gear) and main body ECU (Instrument panel junction block assembly) / OK or STOP
OK: Connection
STOP: No connection
DTC is output if an error occurs in LIN communication
- HINT:
- *: Models with Sliding Roof System