2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Unable to Make or Receive a Call

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

The link between the vehicle and the Toyota Link Call Centre uses GPS for vehicle location and tracking and the Australian digital mobile phone network to transmit and receive voice and SMS (Short Message Service) data.
If the vehicle is outside network coverage, the link to and from the vehicle will not be available and no services can be provided.
The GSM antenna must not be obscured by any objects such as underground car parks, tunnels, bridges, buildings, objects on the parcel tray or after market window tinting. Any of these may affect GSM signal strength.
In most cases, however, as the vehicle emerges from the obstruction or re-enters the digital phone network area, the signal will be available again and any stored data will be transmitted.

INSPECTION PROCEDURE


1. CHECK VIN

  1. B169492
    From the Introduction screen select: Continue.

  1. Select: New Vehicle or Last Vehicle.If New Vehicle selected, select the appropriate model.

  1. Confirm selection.

  1. Confirm VIN.



NG
Go to step 5
OK


2. CHECK GSM MODULE
  1. Using the TDT, from the System menu select: Diagnosis / Data List.

  1. Scroll to GSM module.

  1. Is the GSM module display "Active"?



NO
Go to step 6
YES


3. AUDIBLE SIGNAL
  1. Did you hear 2 beeps when a key pad button is pressed?

  1. Is the red LED ON all the time when the engine switch is on (IG)?



YES
PROCEED TO NO GSM SIGNAL CHART (Click here)
NO


4. CONNECTING TO THE NETWORK
  1. When making a call, does the mayday ECU connect to the network, but only a recorded message saying "the number is not available from this service" is heard?



NO
Go to step 6
OK


5. CALL HELP DESK
  1. Ring TSO help desk, PH 1800 802 726.

  1. TSO will confirm VIN.


NEXT

END

6. CHECK MAYDAY ECU WIRE HARNESS

  1. B169478E01
    Disconnect the mayday ECU connectors A and B.

  1. Check for continuity between the mayday ECU unit connector N46 and connectors A and B.

    OK:
    Less than 1 Ω



NG
REPAIR OR REPLACE MAYDAY ECU WIRE HARNESS
OK


7. CHECK MAYDAY ECU CONNECTORS
  1. Are the mayday ECU connectors tight?



NO
REPAIR OR REPLACE THE CONNECTORS
YES

REPLACE MAYDAY ECU


← Microphone (from Oct 2006)DIAGNOSIS SYSTEM (Oct 2006 – May 2009) →