2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

TL3 Airbag Fault

Diagnostic trouble codes · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The mayday ECU monitors the ignition signal via CAN Bus, and the centre airbag sensor assembly on terminal GSW.
If the mayday ECU is able to monitor the ignition signal and the centre airbag sensor signal successfully, the supplemental restraint system (SRS) is considered healthy. If the mayday ECU is unable to monitor the centre airbag sensor signal, but can monitor the ignition signal successfully, the SRS is considered unhealthy.
DTC TL3 is set if the mayday ECU monitors the airbag signal as not in a healthy or deployed state while the engine switch is on (IG). This will be considered by the mayday ECU as an airbag unhealthy or airbag fault. When the start-up self test runs and fails, the mayday ECU stores the DTC and activates the red status LED.

INSPECTION PROCEDURE


1. DOES THE TDT DISPLAY THE IGNITION SYSTEM ON?
  1. Turn the engine switch on (IG).

  1. Select Diagnosis / Data List / Refresh.

  1. Scroll to display the ignition status.

  1. Is the ignition ON?



YES
DIAGNOSE THE AIRBAG SYSTEM (Click here)
NO


2. CHECK MAIN POWER CIRCUIT
  1. Check the IGN fuse for continuity.

  1. Check the IG2 fuse for continuity.

  1. Check the IG2 relay for correct operation.

    OK:
    Continuity or correct operation



NG
REPLACE THE FUSE OR RELAY
OK


3. CONFIRM CAN OPERATION
  1. Is DTC TL4, CAN Communications Failure also set?



YES
DIAGNOSE THE CAN BUS SYSTEM (w/ Smart Entry and Start System) (Click here)
NO

REPLACE MAYDAY ECU


← TL3 Airbag Fault (Oct 2006 – May 2009)TL30 Red LED Voltage Too High (from Oct 2006) →