TL4 CAN Comms Failure
Diagnostic trouble codes · Vehicles built from Oct 2006
DESCRIPTION
The mayday ECU monitors the centre airbag sensor assembly on terminal GSW, and the CAN Bus for messages.If the mayday ECU is able to monitor the CAN Bus for messages successfully, the CAN Bus is considered healthy. If the mayday ECU is unable to monitor the CAN Bus for messages but can monitor the centre airbag sensor signal successfully, the CAN Bus is considered unhealthy.
DTC TL4 is set if the mayday ECU monitors no CAN communications for 10 seconds while the centre airbag sensor signal is healthy.
INSPECTION PROCEDURE
| 1. CHECK CONTINUITY OF MAYDAY ECU AND WIRE HARNESS |
Connect a digital multimeter between mayday ECU unit connector N46 terminal 1 and ground and check for continuity.

- OK:
- Less than 1 Ω
|
|
||||
| NG | |
| 2. CHECK CONTINUITY OF MAYDAY ECU |
Disconnect the mayday ECU connector B.

Connect a digital multimeter between terminal 5 and ground and check for continuity.
- OK:
- Less than 1 Ω
|
|
||||
| OK | |
| 3. CHECK CONTINUITY OF MAYDAY ECU AND WIRE HARNESS |
Connect a digital multimeter between mayday ECU unit connector N46 terminal 2 and ground and check for continuity.

- OK:
- Less than 1 Ω
|
|
||||
| NG | |
| 4. CHECK GROUND CONTINUITY |
Disconnect the mayday ECU connector B.

Connect a digital multimeter between terminal 5 and ground and check for continuity.
- OK:
- Less than 1 Ω
|
|
||||
| OK | ||
| ||
