TL9 Vehicle Battery Under Voltage
Diagnostic trouble codes · Vehicles built from Oct 2006
DESCRIPTION
Battery voltage is supplied to the mayday ECU unit connector N46 terminal 3 at all times.INSPECTION PROCEDURE
| 1. CHECK DTCs |
 |
Turn the engine switch on (IG).
Select: Diagnosis / DTC List / Current DTC / Clear Current DTCs.
Select: Back / History DTC / Clear Current DTCs.
Start the engine and increase the engine speed to 1000 rpm for at least 1 minute.
Does DTC TL9 reappear?
|
NO |
 |
|
| CHECK CHARGING SYSTEM FOR AN INTERMITTENT FAULT (Click here)
|
|
|
| YES |
|
 |
|
| 2. CHECK BATTERY VOLTAGE |
 |
Turn the engine switch on (IG).
Select: Systems Menu / Diagnosis / Data List.
Scroll to the Battery Voltage.
Start the engine and increase the engine speed to 1000 rpm for at least 1 minute.
Read the voltage display.
- OK:
- Battery voltage:
- 11.6 V - 11.4 V for 30 minutes
- 11.4 V - 11 V for 20 minutes
- 11 V - 1 V for 90 seconds
|
OK |
 |
|
| CHECK CHARGING SYSTEM FOR AN INTERMITTENT FAULT (Click here)
|
|
|
| NG |
|
 |
|
| 3. CHECK MAYDAY ECU VOLTAGE |
 |
- Connect a digital multimeter between mayday ECU unit connector N46 terminal 3 and ground.
Check for voltage.
- OK:
- Battery voltage:
- 11.6 V - 11.4 V for 30 minutes
- 11.4 V - 11 V for 20 minutes
- 11 V - 1 V for 90 seconds
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 4. CHECK GROUND CONTINUITY |
 |
- Connect a digital multimeter between mayday ECU unit connector N46 terminal 4 and ground.
Check for continuity.
- OK:
- Less than 1 Ω
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 5. CHECK MAYDAY ECU WIRE HARNESS |
 |
- Disconnect the mayday ECU connectors A and B.
Check for continuity between the mayday ECU unit connector N46 and connectors A and B.
- OK:
- Less than 1 Ω
|
NG |
 |
|
| REPAIR OR REPLACE MAYDAY ECU WIRE HARNESS |
|
|
| OK |
|
 |
|
| 6. CHECK MAYDAY ECU CONNECTORS |
 |
Are the mayday ECU connectors tight?
|
NO |
 |
|
| REPAIR OR REPLACE THE CONNECTORS |
|
|
| YES |
|
 |
|
|