TL15 Back-up Battery Not Detected
Diagnostic trouble codes · Vehicles built from Oct 2006
DESCRIPTION
The back-up battery is housed in the battery compartment of the mayday ECU. The back-up battery will provide power to the mayday ECU for at least 30 minutes in the event of the vehicle battery being discharged or disconnected.The mayday ECU has a back-up battery charging circuit that maintains the back-up battery state of charge. This circuit also includes an over-current protection device.
DTC TL15 is set if the back-up battery voltage is less than 5 V.
INSPECTION PROCEDURE
| 1. CHECK DTCs |
Turn the engine switch on (IG).
Select: Diagnosis / DTC List / Current DTC / Clear Current DTCs.
Select: Back / History DTC / Clear Current DTCs.
Start the engine and increase the engine speed to 1000 rpm for at least 5 minutes.
Is DTC TL15 reset?
|
|
||||
| YES | |
| 2. MONITOR BACK-UP BATTERY VOLTAGE |
Turn the engine switch on (IG).
Select: Systems Menu / Diagnosis / Data List.
Scroll to the Back-up Battery Voltage.
Start the engine and increase the engine speed to 1000 rpm for 5 minutes.
Monitor the back-up battery voltage during this time.
- OK:
- Greater than 5 V
|
|
||||
| OK | |
| 3. CHECK THE BACK-UP BATTERY VOLTAGE |
Disconnect the back-up battery connector ECU-E from the mayday ECU.

Connect a digital multimeter between the terminals 1 and 2 and check for voltage.
- OK:
- Less than 5 V
|
|
||||
| OK | |
| 4. CHECK BACK-UP BATTERY TERMINAL RETENTION |
Are the back-up battery terminals tight?
|
|
||||
| YES | ||
| ||
