2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

TL36 Green LED Voltage Too Low

Diagnostic trouble codes · Vehicles built from Oct 2006

DESCRIPTION

The red and green status indicator LEDs in the roof console box indicate the current status of the Toyota Link system.
The mayday ECU activates the LEDs by switching a 12 V power supply to each LED ON or OFF.
The colour of the LED indicates the status of the system. If there is a system fault during a call, the LED will flash red; if there are no system faults, then the LED will flash green.
DTC TL36 is set if the red LED voltage is less than 0.5 V for more than one second.

INSPECTION PROCEDURE


1. SELECT ACTIVE MODE
  1. Select: System Menu / Mode.

  1. Does the TDT display the Operating mode, "Active"?



NO
SELECT: SELECT MODE "ACTIVE"
YES


2. PERFORM ACTIVE TEST

  1. B169495
    Select: System Menu / Diagnosis / Active Test.

  1. Using the TDT, select Green LED: ON and OFF.

  1. Observe the LED.

  1. Does the green LED turn ON and OFF?

    HINT:
    Green LED OK



YES
Go to step 5
NO


3. CHECK ROOF CONSOLE BOX VOLTAGE

  1. B169481E02
    Connect a digital multimeter between roof console box connector Q16 terminal 11 and ground.

  1. Turn the green LED ON and OFF as in the previous step and check for voltage.

    OK:
    12 - 14 V



OK
Go to step 5
NG


4. CHECK THE MAYDAY ECU VOLTAGE

  1. B169476E01
    Connect a digital multimeter between mayday ECU unit connector N46 terminal 14 and ground.

  1. Turn the green LED ON and OFF as in the previous step and check for voltage.

    OK:
    12 - 14 V



NG
Go to step 6
OK

REPAIR OPEN CIRCUIT IN THE WIRE HARNESS

5. CHECK ROOF CONSOLE BOX GROUND

  1. B169481E01
    Disconnect the roof console box connector Q16.

  1. Connect a digital multimeter between terminal 8 and ground and check for continuity.

    OK:
    Less than 1 Ω



OK
REPLACE THE ROOF CONSOLE BOX ASSEMBLY
NG

REPAIR GROUND CIRCUIT

6. CHECK MAYDAY ECU WIRE HARNESS

  1. B169478E01
    Disconnect the mayday ECU connectors A and B.

  1. Check for continuity between the mayday ECU unit connector N46 and connectors A and B.

    OK:
    Less than 1 Ω



NG
REPAIR OR REPLACE MAYDAY ECU WIRE HARNESS
OK


7. CHECK MAYDAY ECU CONNECTORS
  1. Are the mayday ECU connectors tight?



NO
REPAIR OR REPLACE THE CONNECTORS
YES

REPLACE MAYDAY ECU


← TL35 Green LED Voltage Too High (from Oct 2006)TL37 Green LED Not Present (from Oct 2006) →