2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

TL42 Module Fault

Diagnostic trouble codes · Vehicles built from Oct 2006

DESCRIPTION

DTC TL42 is set if the mayday ECU detects an internal fault during the mayday ECU self test.

INSPECTION PROCEDURE


1. CHECK DTCs
  1. Turn the engine switch on (IG).

  1. Select: Diagnosis / DTC List / Current DTC / Clear Current DTCs.

  1. Select: Back / History DTC / Clear Current DTCs.

  1. Turn the engine switch off for 1 minute, then on (IG) again.

  1. Is DTC TL42 reset?



NO
THE PROBLEM IS INTERMITTENT, CHECK THE MAYDAY ECU, WIRE HARNESS AND CONNECTORS
YES


2. CHECK MAYDAY ECU WIRE HARNESS

  1. B169478E01
    Disconnect the mayday ECU connectors A and B.

  1. Check for continuity between the mayday ECU unit connector N46 and connectors A and B.

    OK:
    Less than 1 Ω



NG
REPAIR OR REPLACE MAYDAY ECU WIRE HARNESS
OK


3. CHECK MAYDAY ECU CONNECTORS
  1. Are the mayday ECU connectors tight?



NO
REPAIR OR REPLACE THE CONNECTORS
YES

REPLACE MAYDAY ECU


← TL41 Volume Down Button Stuck (from Oct 2006)TL43 GSM Not Logged With Signal Strength Present (from Oct 2006) →