INSTALLATION
Removal / installation · Vehicles built from Jun 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
| 1. INSTALL MAYDAY ECU UNIT |
Install the mayday ECU unit.
Install the 3 reinforcement plates ensuring they are positioned correctly.
Install the 3 nuts.
- Torque:
- 7.2 N*m{ 73 kgf*cm , 64 in.*lbf }
Connect the mayday ECU unit connector N46, GPS antenna connector and GSM antenna connector.
| 2. INSTALL REAR SUNSHADE ASSEMBLY (w/ Rear Sunshade) |
- HINT:
- Follow the steps for installing the rear sunshade assembly (Click here).
| 3. CONNECT BATTERY |
Connect the negative battery cable to the battery.
| 4. RESET BACK-UP BATTERY TIMER |
Use the Diagnostic Tool to reset the back-up battery timer, refer to TDT System Functions (Click here).
- NOTICE:
- Reset the back-up battery only when it is replaced.
| 5. PLACE MAYDAY ECU IN ACTIVE MODE |
Using the diagnostic tool, place the mayday ECU into Active mode, refer to TDT System Functions (Click here).
- NOTICE:
- If the mayday ECU Service mode is not disabled, the system will not have full functionality.
- If a new mayday ECU has been installed into the vehicle, it must be registered with Toyota Link.
- If the mayday ECU Service mode is not disabled, the system will not have full functionality.
