2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Portable Player cannot be Connected Manually/Automatically

Circuit diagnosis · Vehicles built from Jun 2009

INSPECTION PROCEDURE

HINT:
  1. Some versions of "Bluetooth" compatible audio players may not function, or the function may be limited using the radio and display assembly, even if the portable audio player itself can play files (Click here).
  1. Refer to the owner's manual for the operating procedure.


1. CHECK CONNECTED DEVICE SETTINGS
  1. Check if the portable player is registered as a connected device.

    NOTICE:
    If a cellular phone is used as a portable player, it must be registered independently from the registration that is performed for the hands-free system.

    Result:
    Result
    Proceed to
    The portable player is registered as a connected device.
    A
    The portable player is not registered as a connected device.
    B



B
REGISTER PORTABLE PLAYER AS CONNECTED DEVICE
A


2. CHECK SYMPTOMS
  1. Check the connection condition between the portable player and radio and display assembly.

    HINT:
    The portable player cannot be connected under any of the following conditions:
    1. The portable player is connected to another device.
    2. The portable player is connected to the radio and display assembly using the hands-free function.
    3. The radio and display assembly has cleared the portable player registration.
    4. The portable player is off.

    Result:
    Result
    Proceed to
    The portable player cannot connect automatically.
    A
    The portable player cannot be connected manually.
    B



B
Go to step 4
A


3. CHECK AUTOMATIC CONNECTION SETTINGS
  1. Check automatic connection settings of the "Bluetooth" audio.

    1. Turn the ignition switch off.

    2. Turn the ignition switch on (ACC or IG).

      OK:
      The portable player is automatically recognized by the radio and display assembly.



NG
CHANGE SETTING TO ALLOW PORTABLE PLAYER TO BE RECOGNIZED BY RADIO AND DISPLAY ASSEMBLY
OK


4. CHECK PORTABLE PLAYER STATUS
  1. Check the status of the portable player.

    1. Check that the portable player is in standby mode.

    2. Check that the portable player is not connected to another device (headphones etc.).

      OK:
      The portable player is in standby mode or connected to another device (headphones etc.).



NG
CHANGE PORTABLE PLAYER TO STANDBY MODE AND DISCONNECT OTHER DEVICES (HEADPHONES etc.)
OK


5. CHECK USING ANOTHER "BLUETOOTH" AUDIO COMPATIBLE VEHICLE OF SAME MODEL
  1. Check if the portable player can be connected manually/automatically on another "Bluetooth" audio compatible vehicle of the same model.

    OK:
    The portable player can be connected manually/automatically.



NG
PORTABLE PLAYER IS NOT COMPATIBLE
OK


6. REMOVE ADDITIONAL DEVICES WHICH USE RADIO WAVES
  1. Remove additional devices which use radio waves.

  1. Check if the portable player can be connected manually/automatically.

    OK:
    The portable player can be connected manually/automatically.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END


← Noise Occurs or Sound Skips when Portable Player Plays (from Jun 2009)Registered Device cannot be Deleted (from Jun 2009) →